Mission biefing: Achieve reset on demand in Humax IRCI 5400 embeded Irdeto
card reader.
Tools provided: soldering iron, solder, shielded wire, 1kOhm resistor.
"The CAM only uses 5v to switch so I`ve added a 1k ohm
resistor to drop the voltage.
Simply solder the resistor to pin 6 and solder
a wire between that & the 12v socket on the back,which of course u can do
internally.
Regards
grumps"
The example above is for DIY training purposes only. Procedure described
will void your receiver warranty and is not a part of service nor supported
by Humax standard terms of use. Using any third party software to modify your
receiver may be against the law in your country.
[Photo by author]
|